Westinghouse WST5019ME Serie Manual De Instrucciones página 6

OPERATING INSTRUCTIONS
Using as a Dry Iron
The Iron can be used on the dry setting with or without water in
the Water Tank. However, it is best to avoid having water in the
Water Tank while dry ironing.
1. Turn the Temperature Control Dial to the "MIN" setting and
make sure that the Steam Button is in the NO STEAM
position.
2. Stand the Iron in the vertical position (on its Heel Rest) on a
heat resistant surface and plug into a 127V outlet.
3. Turn the Temperature Control Dial to the desired setting.
The red Thermostat Light will illuminate, indicating that the
Iron is heating.
NOTE: For best results, check garment labels for the tem-
perature setting recommended by the fabric manufacturer.
4. Once the Iron has reached the set temperature, the red
Thermostat Light will go off, indicating that the Iron is ready
for use.
NOTE: The red Thermostat Light will continue to cycle off
and on during use as the Iron maintains the desired
temperature.
5. When changing from a higher temperature setting to a lower
temperature setting, wait until the red Thermostat Light
cycles on and then off again before ironing.
6. When finished ironing, turn the Temperature Control Dial to
the "MIN" position and unplug the Iron. Stand the Iron back
in the vertical position (on its Heel Rest) and allow it to cool
completely before cleaning or storing.
WARNING: Never fill the Water Tank while the Iron is still hot.
5