Adjust The Depth (Cp790-Xx); Adjust The Height Of The Push Handles (Cp790-Xx); Before Use; Using Warnings - Moretti ARDEA ONE Helios Smart CP770-40 Manual De Instrucciones

8

8.10 Adjust the depth (CP790-xx)

WARNING!
The adjustment of the wheelchair must be performed by qualified personnel to
assess its suitability and correct configuration.

8.11 Adjust the height of the push handles (CP790-xx)

To adjust the height of the push handle, loosen the knobs at the side ends
of the backrest, adjust the handles to the desired height and tighten the
knobs.
(FIG.11)

9. BEFORE USE

• Inspect the frame for any damage. Check the tubing for cracks and rust, in order to
guarantee the safe for people ant thing.
• Check the correct assembly, in order to guarantee a safe use.
• Check the seat is completely open. If not push the seat down from the lateral frame.
• Check the brake correctly works.
• Make sure the armrests have been positioned correctly.
• Remember that the center of gravity of the wheelchair has been studied with footrests in
the right position, therefore do not use the wheelchair without the footrests because it
could overturn.

10. USING WARNINGS

• The wheelchair cannot be used as a seat on motor vehicles.
• Always make sure that the brake control is properly adjusted and functioning.
• It is recommended to be careful of trapping fingers in some parts like wheels or brakes
when using the wheelchair.
• Remember that the wheelchair surface temperature may increase when exposed to exter
nal heat sources, such as sunlight.
• WARNING! There is a risk of slipping in the presence of gravel or uneven ground or in the
wet. Always adapt the driving method to the conditions of use.
• WARNING! Additional loads hanging from
To adjust the depth of the seat:
• Unscrew the 4 screws that lock the vertical support to the seat
and to the lower frame
• Move the seat support forward or back as needed;
• Screw the screws in the right position;
• Adjust the seat by increasing or reducing the seat available
through the Velcro strips.
(FIG.10) Image for illustrative purposes only
(FIG. 11)
Image for illustrative purposes only
(FIG. 10);