Matco Tools MTHVLP13 Guia De Inicio Rapido página 2

OPERATION
Coating will
Coating will
be light
be heavy
at this point
at this point
WRONG
AIR ADJ. VALVE
Increase/decrease the air flow into
the spray gun. To fine-tune the
air pressure, please use a micrometer
at gun air inlet.
In normal operation, the wings on the nozzle are
positioned horizontally as illustrated here.
This produces a vertical fan shaped pattern. The pattern
is uniquely designed for overlap efficiency (only 1/5 at
top and bottom), and therefore saves substantial
amount of paint.
(Switching the wings vertically is NOT recommended.)
CAUTION
• All operations including maintenance should be carried out ONLY by knowledgeable operators.
• Never aim the Spray Gun towards humans or animals.
• Be aware of the conditions of your surroundings, and keep the spray equipment and the object
being sprayed firmly on the ground at all times.
• Do not exceed the maximum working pressure of the equipment.
• Fluid and solvents can be highly flammable and corrosive. Handle with extreme care and keep away
from fire and electrical hazards.
• Toxic vapors produced by spraying can cause serious damage to health. Always wear protective
equipment and use the Spray Gun in well ventilated areas with a suitable respirator.
• Halogenated hydrocarbon solvents may cause chemical explosions. Use paint materials
which are chemically compatible with aluminum, copper and zinc parts.
• Always release air and fluid pressure before cleaning/disassembling/servicing. A ball-valve installation
is recommended for emergency stop and prevention of unintentional operation accidents.
• Make sure all parts, screws and nuts are intact before putting the Spray Gun into operation.
HVLP ELITE SPRAY GUN
Spray Distance
MTHVLP14 : 305mm(12")-190mm(7.5")
Start
Stroke
Effective
Area
Page 2
Proceed
Pull
Trigger
CORRECT
PATTERN ADJ. KNOB
Turn right for round. Turn left for fan.
Capable of doing shapes from round to oval.
FLUID CONTROL KNOB
Turn right to decrease. Turn left to increase.
A larger pattern width requires more material
to pass through to obtain uniform coverage
on the increase area. Use lock ring to set
adjustment.
MTHVLP13
MTHVLP14
Coating should be even
and wet when spraying
Release End
Trigger Stroke
1809274-14