Getting Started - Softing mobiLink Manual Del Usuario

Getting started

EN
Read this quick guide before you unpack, install and
operate mobiLink.
Unpacking your mobiLink
1. Take the device and the accessory parts out of the
box.
2. Save box and packing material for future use.
3. Verify that the following items are contained
undamaged:

mobiLink device

USB cable (2m)

red and black testing cables with clamp

3 AA batteries
Setting up your mobiLink
1. Depending on your use case (configuration/
parameterization) download the MOBILINKdtm or
the Communication Configuration Tool from the
product website. Scan the QR code on the back page
for quick access.
2. Double-click the setup file to start the installation.
3. Select the installation language.
4. Follow the install wizard instructions.
5. Read the User Guide available for download.
Startup and Operation
Insert the batteries, switch on the mobiLink and wait 5
seconds until the device has started. The operation of
mobiLink requires the use of management tools like FDT
frame applications or configuration tools on Windows PCs
or tablets or smartphones.
See the User Guide for safety requirements and details
on how to set up a USB and Bluetooth communication
and how to configure the fieldbus and HART connection.
During startup mobiLink tries to verify the operation
mode against the connected fieldbus. If fieldbus
terminals are connected to an operating 4-20 mA link this
will compromise the analog process value. Make sure to
use the correct connections and mode.
Safety
mobiLink must be operated by qualified personal only. To
ensure the safety of personnel and equipment, mobiLink
must be used as intended and in accordance with local
laws and regulations. See also the User Guide for safety
requirements and regulations.
4
Transport and Maintenance
Remove the batteries for transport from the device to
ensure that mobiLink is mechanically secured against
being switched on inadvertently. Periodically wipe the
housing with a damp cloth. Do not use abrasives or
solvents. Do not clean the device inside hazardous areas!
mobiLink does not contain user serviceable parts. No
modifications or repair on the device are allowed. The
operator is responsible for the transportation and
maintenance of the product.
Explosion protection
mobiLink has been developed for use in hazardous areas,
classified as Zone 1/Zone 2. It is approved for explosion
group IIC and temperature Class T4 or higher. Make sure
that you use mobiLink only in compliance with local safety
requirements for installation of electrical equipment in
explosive atmosphere. See the User Guide for details.
Do not use the USB communication mode inside
hazardous areas!
Declaration of conformity
This product meets all requirements of the following
applicable EU Directives and harmonized standards (see
overleaf).
 2014/30/EU "EMC"
 2011/65/EU "RoHS"
Bluetooth
This product has been tested and approved for Bluetooth
wireless communication in the following regions and
countries:
 European Union
 USA
 Canada
 Japan
 South Korea
Certification of conformity
This product is IECEx and ATEX certified and was found to
comply with the standards and requirements indicated by
the following marks:
 2014/34/EU "ATEX"
 2014/53/EU "RED"