Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING YOUR HEATER
Once the unit has been properly connected to a grounded electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for the power supply are turned on.
To access the control panel, slowly open the door located on the front of the heater.
HEATER OPERATION
1. Open the door of the unit to locate the control panel.
2. Ensure the power switch is on. You will know that you
have power to the heater when the flame effect is on.
3. Flip the second rocker switch to the right, marked "Ⅰ".
This switch gives you 900W of power to your heater.
This switch is for low-level heating. For high-level heating,
1400W of power make sure that both "Ⅰ" and "Ⅱ" rocker
switches are on.
FLAME OPERATION
1. To switch the flame effect of your heater, flip the power
switch on. You will know that you have power when the
flame effect is on.
2. To adjust the brightness of the flame effect, turn the dial,
from
"Low", to
you desire.
Dimmer Control
"High", until it reaches the brightness
Power
Switches
Power
Flame
Adjuster
~ 5 ~
Low
High
Publicidad
Tabla de contenido
Solución de problemas
