Connecting And Operating A Load/Device - ULTIMATE SPEED USSW 300 B2 Instrucciones De Funcionamiento Y De Seguridad

the red connecting clamp
over the 12 V screw connector
7
(see Fig. 1). Make sure that
the washer is positioned
between the eyelet and the nut
16 .
Tighten the red nut
„
the eyelet is held in place.
Unscrew the black nut
„
the car power inverter
Guide the black eyelet of the
cable with the black connect-
11
ing clamp
connector 8
Make sure that the washer is
positioned between the eyelet
and the nut 17
Tighten the black nut
„
that the eyelet is held in place.
First connect the red clamp to
„
the positive terminal of the car
battery and then connect the
black clamp to the negative
terminal of the car battery.
10
16 such that
17 on
1 .
over the screw
(see Fig. 1).
.
17 such
Instructions for operation
z Connecting and
operating a load/
device
Attention!
Before connecting a load/device
to the car power inverter
sure that the On/Off switch
the device is in the "0" (OFF)
position.
Make sure that the output of the
connected load/connected device
does not exceed the maximum
continuous output of the car power
inverter 1 .
Attention!
Do not switch on the load/device
to be operated yet!.
Connect the plug of the load to be
connected/device to be operated
to the 230 V socket
power inverter 1
Switch the car power inverter
„
1
on, by moving the On/Off
GB/IE/NI/CY/MT
1
, make
4
of
5 of the car
.
21