ULTIMATE SPEED USSW 300 B2 Instrucciones De Funcionamiento Y De Seguridad página 26

Troubleshooting
Problem
No output power
26 GB/IE/NI/CY/MT
Possible cause
The car power
inverter is not
1
completely warmed
up due to low
environmental
temperatures (e.g.
with temperatures
below 10°C in the
winter).
The ignition must be
switched on in order
for the socket for the
car's electrical system
to have power.
The car power
inverter is
1
overloaded.
The car power
inverter has
1
overheated.
Solution:
Switch the car power
inverter on and
1
back off, until the
device connected to the
car power inverter
is supplied with power.
Repeat this procedure
in order to be able to
switch the device on.
Switch the motor
vehicle ignition on or
move to the "1" (ON)
position.
Reduce the load until
it no longer exceeds
the maximum load
given in the technical
specifications.
Wait until the device
has cooled off. Make
sure that there is
sufficient ventilation
clearance. Make sure
that the connected load
does not continuously
exceed the maximum
loading, in order
to avoid the device
overheating again.
1