Basic Operation; Docking/Undocking Your Computer - Toshiba dynadock U3.0 Manual Del Usuario

3. Plug the square end of the USB cable into the USB upstream port on
the back of the dynadock.
(Sample Illustration) Connecting the USB cable to the dynadock
Do not connect the dynadock to your computer before software installation.
NOTE
Some computers may not immediately recognize the dynadock is
NOTE
connected upon start-up. This is related to the computers BIOS start up
sequence but not a malfunction of the dynadock. If this occurs, follow the
steps below:
1. Turn off the computer.
2. Disconnect the dynadock from the computer.
3. Turn the computer back on.
4. Connect the dynadock to the computer once the computer's operating
system has loaded.

Basic Operation

Docking/Undocking your computer

For docking your computer, plug the square end of the USB cable into
■
the USB upstream port on the back of the dynadock and plug the other
end into your computer. The computer will be docked.
For undocking your computer, directly unplug the cable from the
■
computer. The computer will be undocked.
If a USB storage device is connected to the dynadock, make sure you save
NOTE
the data located on the USB device, and then remove the USB device first
before undocking.
User's Manual
dynadock™ U3.0
EN-19