Amann Girrbach ceramill transferkit Modo De Empleo página 7

All other plates must be clipped onto the fixation
plate with the clasp.
Using the No Plast: Fix the model in the No Plast
Loosen the screws at the middle of the No Plast
and position the model in the scanning focus.Fix
the position with the knurled head screw and then
tighten with the Allen screw using the Allen Key
CooRdInatIng the aRtex FIxatoR
Before the Artex Fixator can be used in the scan-
ner, it must first be encoded using the Splitex Key.
Fixator base
Adhesive
Splitex Plate
Splitex Key
Fixator upper
. directions:
#
_ Open fixator
_ Place Splitex key onto upper section
_ Place Splitex plate onto key
_ Apply glue (Loctite) to the underside of
the Splitex plate
_ Spray activator onto the lower section of the
fixator
_ Close fixator down to the end position and
fix it with the lateral screw
_ Cure according to glueing instructions
_ Open fixator
_ Remove Splitex key
U S e R m a n U a l
gB
7