Delivery Includes; Temperature Measurement - Kübler CODIX 529 Instrucciones Para La Puesta En Servicio

5. Connections
1 10–30 VDC
2 GND
3 GND
4 LATCH
5 0 (4)–20 mA
6 Analogue GND
7 0 (2)–10 V DC
6. Technical data
Display:
Range of input signals
Resolution:
Linearity:
Zero adjustment: automatic
Temperature drift:
Measuring rate: 0.5 measurement/sec ....
Current measurement:
Voltage measurement:
Input resistance:
Max. voltage:
Elimination of power line hum:
Supply voltage: 10...30 VDC,
Current consumption:
Ambient temperature:
Storage temperature:
Data retention:
Weight:
Protection:
Page 4
5-digit 7-segment red
LED-Display,
8 mm high characters
0...10 V DC
2...10 V DC
0...20 mA
4...20 mA
14 bits
< 0.1% ± 1 digit at an ambi-
ent temperature of 20°C
<70ppm/K
2 measurements/sec
Voltage drop:
max. 2.0 V at 20 mA
Current limitation: 50 mA
>1 MV
30 V
digital filter at 50 Hz
galvanically isolated
max. 50 mA
-10°C...+50°C
-25°C...+70°C
via EEPROM 1 Million of
memory cycles or 10 years
approximately 50 g
IP65 (front)
EMC:
Noise emission:
Noise immunity:
Cleaning:
The front of the unit is only to be cleaned with
a soft wet (water!) cloth.
Error messages:
Err 0*
Err 3*
Err 4**
Err 5*
* Please send the device back for checking
** Please check input signal and programming

7. Delivery includes

- Digital display with analogue inputs
- Panel mounting clip
- Bezel for screw mount, panel cut-out
50 x 25 mm
- Bezel for clip mount, panel cut-out 50 x 25 mm
- Sealing
- Tack dry symbols
8. Examples

8.1 Temperature measurement

A temperature sensor with linear characteristic
(non-linear sensors, e.g. thermocouples have
to be linearised) supplies 0 V at -10°C and
10 V at 80°C.
0...10 V is chosen as input range.
Assign -10 as „displayed value at min. input
signal" to the lo west input level (0 V) and 80
as „displayed value at max. input signal" (10V).
The device is now tuned to the sensor, inter-
mediate measurement values and their corre-
sponding display values can be calculated.
EN 55011 Class B
EN 61000-6-2
A/D section error/defect
EEPROM error/defect
Analogue input exceeds the
measuring range
EEPROM error/defect.
Device not calibrated