Sanus Systems VMPL2 Instrucciones De Armado página 6

Step 5: Attaching the Monitor Brackets to a television with recessed threaded inserts.
WARNING: DO NOT LAY THE TELEVISION FACE DOWN ON THE GLASS, lean it up against a wall or other solid surface!
Laying the television down on the glass may cause permanent damage.
The Monitor Brackets (c) should be placed as vertically close to center of the television as possible before installation. If your TV has
threaded inserts that are recessed and requires either a M4 or M5 diameter bolt, thread a M4 x 30 (f) or a M5 x 30 (h) Bolt through the
appropriate Lock Washer (m,n), an M4/M5 Washer (t), the Monitor Bracket, an M4/M5 Washer, a M4/M5 Spacer (q) and into the TV as
seen in Detailed View A of Diagram 5. If you determined that your TV requires a Bolt with a M6 or M8 Diameter, thread a M6 x 35 (j)
or a M8 x 40 (l) Bolt through the appropriate Lock Washer (o,p), the Monitor Bracket, a M6/M8 Spacer (r) and into the TV as seen in
Detailed View B of Diagram 5. Proceed to tighten the Bolts firmly with a phillips screw driver.
Detailed View A
t
q
Step 6: Choose mounting position:
You can mount your television in either of two positions:
flat or at a 5 degree downward tilt. To mount the television
flat to the wall use only the Monitor Brackets (c). To mount
the television in the 5 degree tilt position you must first add
two Gussets (d) to each Monitor Bracket with two Carriage
Bolts (w) and two Gusset Nuts (x) as shown in Diagram 6.
Step 7: Hang the TV onto the Wall Plate:
First hook the Monitor Brackets (c) over the top of the Wall Plate (a), then let the bottom of the Monitor Brackets rotate in under the
bottom of the Wall Plate. This process is shown with the flat mount option in Diagram 7a, and with the 5 degree tilt option in Diagram
7b. Once the TV is in place, insert the Safety Bar (b) into the slots in the bottom of the Monitor Brackets so that it sits behind the bottom
tab on the Wall Plate as shown in Diagram 7c. The bend should face toward the wall. Once the bar passes out the other side of the Wall
Plate a padlock can be added to the hole in the Safety Bar for additional security.
Diagram 7a
c
a
wall
f,h
m,n
t
Diagram 7b
c
d
a
slot for safety bar
wall
Diagram 5
Diagram 6 Detailed View
Diagram 7c
Detailed View B
j,l
r o,p
c
w d d x
a
b
c