Schumacher Electric SC-200A Manual Del Usuario página 10

Voltage Selector Switch
Use the Voltage Selector switch to set the output voltage of the charger
to either 6 volts or 12 volts to match the battery being charged.
12. OPERATiNG iNSTRUCTiONS
accordance with the assembly instructions before it is used.
The charger does not have an ON/OFF switch. The On and Off
commands are controlled by plugging the SC-200A into a 120V AC
electrical wall outlet only after the battery connections have been
made and the Voltage Selector switch has been set.
Charging
1. Ensure that all of the charger components are in place and in
good working condition, for example, the plastic boots on the
battery clips.
2. Connect the battery following the precautions listed in sections
6 and 7.
3. Select the appropriate settings for your battery.
4. Connect the AC power following the precautions listed in section
8. Make sure to place the charger on a dry, non-flammable
surface, like metal or concrete.
5. To disconnect, reverse the procedure.
Thermal Runaway
As a safety precaution, the charger automatically reduces the current
if it detects the battery may be getting too hot.
NOTE: This charger is equipped with an auto-start feature. Current
will not be supplied to the battery clips until a battery is properly
connected. Meaning, the clips will not spark if touched together.
Using The Quick-disconnect Cable Connectors
Connect any of the three output cable assemblies to the charger in
seconds. Make sure to place the charger on a dry, non-flammable
surface like metal or concrete.
NOTE: Never connect the clamp and ring terminal connectors
together for use in other applications, such as external battery or
other power source charging, or to extend the output cable length, as
reverse polarity and/or overcharge conditions will occur.
This battery charger must be properly assembled in
• 10 •