Operating The Sensor; Care And Cleaning - Glacier bay 67536-0508D2 Guía De Uso Y Mantenimiento

Operation (continued)
2

Operating the sensor

NOTE: The sensor is active only when the handle is in the
ON position.
□
Turn the handle (1) away from the faucet to the
full on position. Turn the water on by activating
the sensor (2) by waving your hand within
2-3/8 inches of the sensor.
□
Pulling the handle towards yourself will turn
the water to cold. Pushing the handle away
from yourself will turn the water to hot.
□
If you are having trouble with the sensor,
please refer to the troubleshooting section.
If you want to use the faucet without the
sensor feature, then you can refer to step 6.
Then, turning on the water can be done by
moving the handle away from the faucet
to the full on position.
NOTE: As a water saving feature, the water will turn off
automatically after 3 minutes of continuous flow.
3
Removing the quick connector
(not required)
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.

Care and Cleaning

□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
0
3
min.
45
30
Squeeze
1
14
15
Cold
1
2
2
Pull
down
1
Hot