Installation; Preparing For Installation - Glacier bay 67536-0508D2 Guía De Uso Y Mantenimiento

Installation

1

Preparing for installation

CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet. Clean the mounting surface.
□
Before installation, remove the quick connector (K)
from the free end of the hose by unscrewing it in
a counterclockwise direction.
2
Installing the faucet assembly
2a
NOTE: This step is for no escutcheon installation (optional).
□
Install the faucet body (A)-including supply
hoses and sensor cable (1)-through the hole
in the sink.
A
1
2b
NOTE: This step is for escutcheon installation (optional).
Silicone sealant is required under the gasket (G).
□
Place the escutcheon (F) and gasket (G) on the
holes in the sink.
□
Install the faucet body (A)-including supply
hoses and sensor cable (1)-through the hole
in the escutcheon (F).
4
K
F
G
A
1
F