Locating Level Vial Instructions; Model Hc-300 Description, Specifications And Accessories Description - RIDGID HC-450 Manual De Operación

HC-450/HC-300 Hole Cutting Tools
Locating Level Vial
Instructions
The rear base of the HC-450 Hole Cutting Tool hous-
es a level vial. This vial is used to ensure that series
of holes align. (See Figure 9.)
Figure 9 – Model HC-450 Level Vial
In the event that the hole location is angled by a cer-
tain amount, the vial can be rotated within the base to
reflect the deviated angle.
In new pipe installation, the vial can be pre-set and
used to repeat hole orientation. As long as the vial is
showing level, the hole angles will align.
Model HC-300 Description,
Specifications and Accessories
Description
The RIDGID Model HC-300 Hole Cutting Tool is
designed to cut holes up to 3" diameter into steel pipe.
The multiple hole size allows the use of Mechanical
T's ® , Hookers ® , Vic-O-Lets™, Weld-O-Let™ and other
fittings for branching unpressurized pipelines.
The HC-300 features a 1
modate all size of holes up to 3" diameter and stan-
dard hole saw arbors up to
An integral motor and gear reduction optimizes the
performance and saw life in the capacity range. A sin-
gle feed handle and ON/OFF switch allows for easy
operation. The compact two-piece design allows the
HC-300 to be used in tight quarters and difficult-to-
reach locations.
NOTE! Mechanical T's, Hookers, and Vic-O-Lets are reg-
istered trademarks of Victaulic Tool Company.
8
" capacity chuck to accom-
/
2
" Hex ( " chuck size).
/ /
7 1
16 2
Ridge Tool Company • Elyria, Ohio • U.S.A.
Figure 10 – Model HC-300 Rear View
Figure 11 – Model HC-300 Front View
Figure 12 – Model HC-300 Isometric
WARNING
The HC-300 is not a hot tapping tool. Care must
be taken to ensure the system is drained and
de-pressurized to prevent serious injury and/or
property damage.