Cadet RBF Serie Guía Para El Propietario página 3

Figure 3
STEP 1
Remove Existing Heater
A. WARNING! Before removing grill, turn the electrical
power off at the electrical panel board (circuit breaker or fuse
box). Lock or tag the panel board door to prevent someone
from accidentally turning the power on while you are working
on the heater. Failure to do so could result in serious electrical
shock, burns, or possible death.
B. It is important that you verify power has been turned off and no
power is going to the heater before proceeding. Circuit breakers
are often not marked correctly and turning the wrong breaker
off could mean electricity is flowing to the heater, even if the
heater does not appear to be working. If you are uncomfortable
working with electrical appliances, unable to follow these
guidelines, or do not have the necessary equipment, consult
a qualified electrician.
C. Once you verify the power has been turned off correctly,
proceed to next step.
D. Remove screws and take off grill.
E. Separate supply wire and lead wire connections.
Installation Instructions
Retrofitting RBF101 as Replacement for RB Heaters
RB/RBF
Wall Can
For installation in newer RB/RBF wall can only.
STEP 2
Install Heater Assembly Into Wall Can
Install spring clips on wall can edge, two at the top and two at the
bottom (See Figure 3). Lay heater assembly on its front surface and
position rocker switch to be installed at bottom of wall can
(See Figure 4). Make the connection of the supply wires to the
lead wires from the rocker switch. Position the heater assembly
to fit adapter plate to the surface of the wall can (See Figure 3).
Important: Push wires into bottom of wall can during insertion.
Be sure that wires are not caught between motor and wall can.
Attach assembly using the four #10 32 x ½ inch machine screws;
two at top and two at bottom.
STEP 3
Install Grill Frame and Grill
Remove protective film from frame and grill before installing.
Place grill frame outside top and bottom flanges of the heater
assembly. Place grill over frame and secure with the four finishing
washers and four #10 x 1½ inch Phillips oval head sheet metal
screws (See Figure 3). Start all four screws before tightening.
(Note: Over tightening screws may damage grill.)
Figure 4
Supply
Wires
Rocker Switch
3