Art. 394 - 395 - 396 -381 - Cebora 451.00 Manual Instrucciones

3.2

Art. 394 - 395 - 396 -381

a) Make sure the power source power cord is disconnected
from the power socket
b) remove the two plastic frames of the power source
c) remove the top and left side panel of the power source
(power source front view);
d) fix the support 1 to the inside buffle using the express 2
screw holes crews provided, as indicated in Fig. ;
e) fix the power supply 2 to the support 6;
f) fix the 10-pin circular connector of the wiring 4 in the
express hole in the rear panel of the power source (CN5
in Fig.);
g) Connect the wiring 4 to the power supply 2, RED wire
to the +V terminal , BLUE wire to the -V terminal;
h) Connect one end of the wiring 3 to the power supply
2, terminals L-N and the other end to the transformer
(5), (55 for Art. 381.00) terminals 0 - 220 . Close the
power source carpentry performing the steps b, c in
reverse way.
3301068
E
N
9