Installation - ASA Electronics ASABG6 Manual Del Usuario

INSTALLATION

NOTICE: To achieve the best result of the power amplifier, it is strongly recommended that you entrust qualified
professionals for the power amplifier installation. Although this manual provides guidance on the power amplifier
installation, if you do not possess the required tools and experience, you are not recommended to install the power
amplifier on your own.
Important Notes
•
Before you begin, always disconnect the negative battery terminal and turn off all devices.
•
Wear protective glasses during installation.
•
When drilling holes and installing screws, make sure both sides of the mounting position are clean. Screws will likely
penetrate the other side of the baffle.
•
During wiring, separate the signal line from the power and speaker line to prevent interference.
•
Install carefully to ensure safety and insulation of the device.
Power Amplifier Installation
Choose Installation Location
The power amplifier needs air to prevent it from overheating. The radiator of this unit is the power amplifier housing. Maintain
good ventilation surrounding the radiator housing to prevent overheating and poor power output of the unit. Limit unit to excess
water and seal the wiring access from water.
Installation Screws
Power Connection
This amplifier has two power and two ground wires in the power connector. You MUST connector both power wires to 12V and
both ground wires to ground.
3
ASABG6