How To Use - Overmax Multipic 4.1 Manual De Usuario

Possible ways of installing the projector (see: fig. 6)
Contact the professional installer to assemble the projector below the ceiling.
Follow the instructions below to assure proper positions of the projector.
1.
Ceiling assembly for front projection.
EN
2.
Placing the projector on the platform for front projection.
3.
Ceiling assembly for rear projection.
4.
Placing the projector on the platform for rear projection.
Warning: The projector may get damaged and be irreparable if it has been
wrongly assembled on the ceiling or other surface.
• Use the projector in the environment in which the temperature does not
exceed 5 °C - 35 °C. In case you do not follow this range, the projector
may fail.
• The failure may occur if the projector is located in the dusty, wet, humid
or smoky area.
• Poor ventilation may lead to overheating which leads to damage to the
projector and may pose a threat to one's life.

3. How to use

How to switch on and off:
• When the projector is connected to source of power supply, it gets ready
for work.
• To switch the projector on or off, set the power key at the back of the
casing in on (-) position. Press the on/off key on the remote control or
projector.
How to adjust sharpness and how to correct screen inclination:
• Place the projector so that the lens remains perpendicular to the wall or
board on which the image is to be displayed.
• To improve sharpness of the image, turn the sharpness knob (9) located
at the side of the casing.
• If the image is not displayed perpendicularly, it will be deformed.
• Deformed image in the shape of the trapezoid can be corrected with the
use of a image shape change knob (10). See: fig. 7
How to connect to source of multimedia through cable (see: fig. 3)
The projector allows displaying the image from various devices. Depending on
the device, please use the relevant input at the back of the casing.