How To Use - Overmax Multipic 5.1 Manual De Usuario

Image shape adjustment
Check the trapezoid adjustment diagram (fig. 5)
X
– wrong installation
– desired installation
✓
Projector installation methods
Contact the professional assembler to fix the projector under the ceiling.
Suitable positions of the projector (fig. 6):
1.
Ceiling assembly for frontal projection.
2.
Placing projector on platform for frontal projection.
3.
Ceiling assembly for rear projection.
4.
Placing projector on platform for rear projection.
Warning: The projector may be irreparably damaged in case of wrong
installation on the ceiling or other surface.
• The projector must only be used in the place in which temperature ranges
from 5 °C to 35 °C. If you do not stick to this rule, the projector may fail.
• The failure may occur if the projector is in the dusty, wet, humid or
smoky area.
• Insufficient ventilation may lead to overheating, which in turn may result
in damage to the projector or life-threatening situations.

How to use

Switching on and off
• When the projector is connected to source of power, it switches into
standby mode. The indicator light glows in red.
• To switch the projector on or off, press the switch at the top of the housing
or press on/off key on the remote control. If the indicator light glows in
blue, it means the projector is ready for operation.
Sharpness adjustment
• Position the projector so that the lens is perpendicular to wall or screen
the image is to be displayed on.
• To improve the sharpness of the image, turn the sharpness knob on the
side of the housing to make the image sharp.
• If the image is not displayed perpendicularly, it will be distorted.
Connection to source of multimedia through cable
The projector allows you to display image from various devices. Depending
on the device, you need to use a suitable input at the back of the housing.
EN