C
E
hiCCo
asy
IMPORTANT! READ CAREFULLY AND KEEP FOR FU-
TURE REFERENCE.
WARNING: KEEP THE PLASTIC BAGS OUT OF REACH
OF CHILDREN TO PREVENT CHOKING HAZARD.
WARNING
• WARNING: Never leave the child unattended.
• WARNING: Always use the child restraint and table at-
tachment systems.
• WARNING: Always check the security and the stability of
the product before use.
• WARNING: Maximum weight: 15 kg.
• WARNING: This product is intended for children able to
sit up unaided. Age range: from 6 months onward.
• WARNING: Do not use tablecloths or other objects on the
table that may interfere with the proper operation of the
fastening devices. Keep the table structure and surface
clean and dry.
• WARNING: Check the locking screws regularly and tight-
en as needed. Check also the pad.
• WARNING: Do not use the product when any compo-
nent is broken, torn or missing.
• WARNING: Do not use accessories or replacement parts
other than those approved by the manufacturer or dis-
tributor.
• WARNING: Do not fasten the product in points where
your child could use his feet to push against parts of the
table, chairs or other structures thus making the seat
move and creating situation of instability.
• WARNING: This product is not fit for all types of table. Do
not fasten to: Tables with glass or crystal surfaces or the
like; Tables with uneven or rough surfaces; Tables with one
leg only; Card tables; Camping tables; Table leaf.
• WARNING: Make sure that the table does not tip over
when the product is fastened and in use.
• The table top must have a minimum thickness of 19 mm
and a maximum of 38 mm.
• Do not fasten to drawers or mobile parts of the table.
• Do not hang objects on the seat that may alter its stability.
• Do not fasten or lock the seat when the child is in it.
• Do not use the seat for more than one child at a time.
• Always supervise children playing near the seat.
ASSEMBLY
Join the two arms (Fig. A) to the table seat frame. Proceed
as follows: Join the arm with the red symbol to the side of
the seat (Fig. B) with the red arrow (as shown in Fig. 1A/1B).
Connect the arm and ensure that that both of the pins are
locked into position (diag. 2). A double click will indicate
that the pins are locked correctly into position. Repeat the
operation on the other arm. Fix both the cover fastenings
with the automatic studs by passing them around the
frame (Fig. 3).
HOW TO USE
Press the catches on the lower joints and push the pins
in a downward direction (Fig. 4). Incline the table seat by
raising the rear section and position it on the table surface
(Fig. 5). Push until it comes to a halt (Fig. 6).Push the joint
pin upwards until it makes contact with the table surface
(Fig. 7/8). Repeat this operation with the other joint.Make
final adjustments by rotating the handgrips situated under
L
unCh
30° C
the joints in an ANTICLOCKWISE direction, until the seat
is securely fixed (Fig. 9). Repeat this operation with both
the handgrips. Check they are securely fixed by pushing
the seat away from the table. Unfasten the double safety
belt and seat the child (Fig. 10). Fasten the safety. Do not
place chairs or similar objects under the table seat while
in use. Detach the seat from the table only after removing
the child. To remove the table seat from the table, turn the
knob in a CLOCKWISE direction until the initial position is
reached. Then press the buttons on the joints and the lock-
ing pins will unlock automatically. If necessary, exert gentle
pressure on the knobs.
REMOVABLE LINING
Unfasten the catches of the cover (Fig.11).
Unfix the two arms by pressing the two pins on both sides
(Fig.12/13).
Unfasten the waist harness from the slots. At this point it is
possible to remove the cover from the frame. Repeat the
operation in reverse to replace the cover, being careful that
the harness passes through the slots correctly (Fig.14).
WASHING INSTRUCTIONS
Release the fastening at the centre of the seat and pull out
the rigid base (Fig.15). Follow the instructions on the label
carefully. After each washing check the condition of the
fabric and the seams.
Wash by hand in cold water
30° C
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
MAINTENANCE ADVICE
• Periodically check the seat for broken, damaged or miss-
ing parts: If this is the case, do not use it.
• Clean the plastic parts with a soft cloth soaked in water.
• Never use abrasive detergents or solvents.
• In case of contact with water, dry the metal parts to pre-
vent rust from forming.
WARRANTY
The product is guaranteed against any conformity defect
in normal conditions of use as provided for by the instruc-
tions for use.
The warranty shall not therefore apply in the case of dam-
ages caused by improper use, wear or accidental events.
For the duration of warranty on conformity defects please
refer to the specific provisions of national laws applicable in
the country of purchase, where provided.
8