Changing The Battery - IKEA TRADFRI E1766 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

While pressing the button the blind is
lowered (until wished position or max
has been reached), if the button is
release the blinds stop.
Move blind up to top position
using buttons on Blind.
Single press the Upper (Top) button on
the Blind until blind has reaches the top
position.
Move blind down to preset level
using buttons on Blind.
Single press the Bottom (Lower) button
on the Blind until blind has reaches the
bottom position.
Move up blind using buttons on Blind.
Press and hold the Upper (Top) button
on the Blind.
Move down blind using
buttons on Blind.
Press and hold the Bottom (Lower)
button on the Blind
Set maximum level of extension
Move the blinds to the desired position
using the Open/Close remote or the
buttons on blind. When blind is at the
desired position, you can double press
the up or down button on the blind to
save this position as the new maximum
level of extension.
If you would like to clear the maximum
level of extension setting, first move the
blind to the top position. Afterwards,
double press either up or down button
on the blind .
You cannot perform this setting using
the Open/Close remote.
FACTORY RESET YOUR DEVICE
For wireless Open/Close remote:
Press the pairing button 4 times within
5 seconds.
For wireless roller blind:
Press on both buttons for 5 seconds. A
LED will blink once to confirm the reset.
For wireless signal repeater:
Push a pin into the pinhole on bottom
of the signal repeater for at least 5
seconds.
After reset the signal repeater you must
pair the Open/Close remote to the
signal repeater and then pair the Open/
Close remote to the roller blind again.

CHANGING THE BATTERY

When the wireless Open/Close remote
is used regularly and as intended, the
battery will last for approximately 2
years.
When it's time to replace the battery, a
red LED indicator will flash when you
toggle the Open/Close remote.
Open the rear cover, and replace the
battery with a new CR2032 battery.
CAUTION!
Risk of explosion if battery is replaced
by an incorrect type. Dispose of used
batteries according to the instructions.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido