Acoplamiento De Un Brazo Para Monitor - Humanscale M/Power Guia Del Usuario

ST EP 2 ST EP 2 PASO 2
Tighten Clamp Tighten Clamp Apriete la pinza
• • Tighten both set screws into bracket to a snug fit (fig. A) Tighten both set screws into bracket to a snug fit (fig. A)
• Apriete a fondo los dos tornillos prisioneros del soporte (fig. A)
ACOPLAMIENTO DE UN BRAZO PARA MONITOR A M/POWER
ATTACHING A MONITOR ARM TO M/POWER ATTACHING A MONITOR ARM TO M/POWER
BR A ZO PA R A MONITO R M2
M2 MONITO R A RM M2 MONITO R A RM
Ajuste la pinza de la base para una profundidad
correcta de la superficie de trabajo
Adjust Base Clamp for Correct Work Surface Depth Adjust Base Clamp for Correct Work Surface Depth
• Quite el tornillo prisionero (fig. G) de la base con una llave Allen de 3 mm
• • Remove set screw (fig. G) from Base using 3mm hex key Remove set screw (fig. G) from Base using 3mm hex key
• Inserte el brazo para monitor en el tronco de la base (fig. H) con la ranura
• • Insert Monitor Arm into the Base stem (fig. H) with its slot facing the rear Insert Monitor Arm into the Base stem (fig. H) with its slot facing the rear
orientada hacia atrás
• • Reinsert the set screw and tighten so that the arm is unable to lift out Reinsert the set screw and tighten so that the arm is unable to lift out
• Vuelva a introducir el tornillo prisionero y apriételo de manera que no se
and the 180º stop* is engaged and the 180º stop* is engaged
pueda extraer el brazo hacia arriba y que el tope* de 180° esté engranado
(*arm won't be able to swivel past the rear desk edge) (*arm won't be able to swivel past the rear desk edge)
(*el brazo no podrá girar más allá del borde trasero de la mesa)
• • Proceed to the "Attach VESA Bracket to Monitor" step Proceed to the "Attach VESA Bracket to Monitor" step
• Consulte el paso «Monte la placa VESA en el monitor»
in the main M2 instruction guide in the main M2 instruction guide
del manual de instrucciones principal del M2
8 8
8
F A A
H H
G G