Yakima LANDING PAD 6 Manual De Instrucciones página 2

Remove cover from Landing Pad.
Use assembled to determine
placement on vehicle.
With the SkyLine or Control Tower cover
open, mark the outline of the holes on the
vehicle roof with a #2 pencil.
1033033C-2/12
Attach SkyLine
or Control Tower
to Landing Pad.
Arrange Towers on canopy from front to back and side
to side. Place Towers considering the following:
Center punch
the holes.
Use eye
protection!
• Design and strength of
construction of vehicle.
• Compatibility of accessories
and crossbar spread
requirements (see side bar).
• Easy access to loaded
accessories.
NoTE: IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT
THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES,
YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL
INSTALLER SUCH AS A QUALIFIED GARAGE OR AUTO BODY SHOP.
Drill 1/8"
pilot holes.
Do not drill through Landing Pads.
Close cover.
CRoSSbAR REqUIREMENTS:
The distance between
the Yakima crossbars is
determined by the accessories
you wish to carry.
Refer to the instructions for the
accessory to determine how
much crossbar spread your
accessories require.
• Drill final hole size
with 1/4" drill bits.