Making An Espresso - Lelit Elizabeth Manual De Instrucciones

VIP Line - Elizabeth - PL92T
Steam
D.7 Point the steam wand (6) onto the cup-holding grate (12)
D.8 Turn the steam knob (10) counter clockwise.
D.9 When steam comes out from the nozzle, turn the knob (10) clockwise to
close it.
Note.
14
in stand-by (energy saving status). The display and the heating element will be switched
off and the coffee switch (2) will flash every 3 seconds to indicate the stand-by status. To
restart the machine, you'll have to press the coffee switch (2).
to start

Making an Espresso

Thanks to the pre-set function settings, the machine is immediately ready to
dispense espresso coffee. To change the settings, please refer to "Changing the
LCC settings" section.
Note.
organoleptic qualities, the flavour and aroma of an Espresso.
E
Preparing the machine for making coffee
E.1 Turn on the espresso machine by pressing the main on/off switch (1). The
display (11) will show the Lelit logo, the three switches and the gauge will go
on for a short time.
E.2 Insert the filterholder (e) without coffee firmly onto the coffee distribution
group (13), so as to align the handle with the padlock symbol on it.
E.3 On the LCC display (11) you'll see the water boiler temperature flashing.
This will grow until the set temperature will be reached.
E.4 Wait until the bar is fully loaded and "Ok" appears on the display. This way
the machine will reach the set temperature.
E 5 After reaching the desired temperature, the bar will disappear, and the
machine will be ready for use.
F
Distributing the coffee
F.1 Insert the selected filter into the pre-warmed filterholder (e).
F.2 Fill the filter with the desired quantity of ground coffee.
Note.
F.3 Press the coffee with the tamper (a) and clean any coffee residues from the
If the machine hasn't been used for 30 minutes or more, the machine will go
The machine comes with a cup warmer (8). Using warm cups enhances the
We suggest 7 g for one cup and 14 g for two cups.