Selecting & Confirming Input Signals - JVC BD-X200E Instrucciones

Settings & Controls for Recording
Selecting & Confirming Input Signals
The selection of audio and video input signals is carried out from the INPUT SELECT MENU screen as described below. In
addition, the type of input signals that have been selected can be confirmed on the front panel.
Video input indicators
BUSY
OPEN/CLOSE
OPTION DV Y/C LINE
SET UP
SET
TOP
MENU MENU
INPUT SELECT MENU screen
INPUT SELECT MENU
MENU
INPUT SELECT
Item
INPUT SELECT
Note
Setting of INPUT SELECT will not be possible when REMOTE SELECT from the REMOTE MENU screen has been set to
DV(MASTER), DV(SLAVE), or DV(TRIGGER).
DV signals will be used for input at these times.
Confirming Input Signals
OPTION DV Y/C
E-32
Selecting Input Signals
Stop the DVD recorder.
1.
SET UP button
2.
SET button
LINE
3.
This parameter is used to select the audio and video input signals.
LINE : The composite video signal from the VIDEO LINE IN terminal and the analog audio signals
from the AUDIO IN terminals are to be used.
Y/C : The YC separate signal from the Y/C IN terminal and the analog audio signals from the
AUDIO IN terminals are to be used.
DV : The audio and video signals from the DV IN/OUT terminal are to be used.
The type of video signals that have been selected for input can be confirmed
using the video input signal indicators on the DVD recorder's front panel.
LINE
Specifically, the indicator corresponding to the type of input signal selected
using INPUT SELECT will be lit up or flashing.
Lit
Flashing : The selected signal is not being received.
Open the INPUT SELECT MENU screen.
q Press the SET UP button to display the Setup Menu.
w Select INPUT SELECT using the 6 and 7 buttons and then press the
SET button.
Make the required settings on the INPUT SELECT MENU screen.
q Select the parameter to be set using the 6 and 7 buttons, and then
press the SET button to display a list of possible settings.
w Select the required setting using the 6 and 7 buttons, and then press
the SET button to adopt this setting.
Complete the setting process.
To do so, carry out one of the following procedures.
• Select MENU and press the SET button to return to the Setup Menu.
• Press the SET UP button to return to the normal screen display.
Description
: The selected signal is being received.