Sliding Desk Mount
D - For installation with minimal clamp space:
Skip to step 3, if the Clamp Mount is not attached.
1
Remove Base Cover (H) by lifting it up and off.
2
Loosely attach Sliding Clamp (L) to the Base
Plate (M) with the Base Screws (J). Do not
tighten these screws yet.
3
Slide the Clamp all the way against the back
edge of the work surface.
4
Finish tightening the three Base Screws.
Bolt-Through Mount
E - For installation on a work surface with no
space for a clamp system:
Skip to step 3, if the Clamp Mount is not attached.
1
See steps 1D – 1, 2 to remove Clamp Mount.
2
Remove the Post Bolt (N) from under the base using the
10 mm hex key (P)
3
Pass the Bolt-Through Adapter (R) through the base and
into the Post. Use the 16 mm wrench (S) to tighten the
adapter.
4
Drill a hole (1/2" – 4") through the work surface in the
desired location.**
5
Position the Base over the hole (T).
6
Align Bolt-Through Plate (U) under the work surface.
Pass the Bolt (V) through the hole in the plate and screw
into the Bolt-Through Adapter using the 10 mm hex key.
** The Bolt-Through Mount will accommodate holes and
grommets up to 4" (102 mm) in diameter. Holes 2" or larger
will allow cables to be routed through before installation of
the mount.
4
①
H
②
N
④
U
V
③
P
R
J
L
S