Stamps, Signs And Stickers; Installation; Hoses And Connections; Methods To Prevent Freezing - Chicago Pneumatic 4123 Instrucciones De Seguridad Y De Funcionamiento

Safety and Operating instructions

Stamps, signs and stickers

Signs and stickers with important information
about personal safety and machine care are
mounted on the machine. The signs and stickers
must always be legible. New signs and stickers can
be ordered from the spare parts list.
WARNING
To avovid injury
A
before using or
servicing tool, read
and understand
separately provided
safety instruction
PARTS CAN EJECT
FROM TOOL
DRAIN AND DISCONNECT
AIR SUPPLY FORM TOOL
BEFORE REMOVING LOCK
SPRING FROM RETAINER
P157290
A. The warning symbol together with the book
symbol means that the user must read the
Safety and Operating instructions before the
machine is used for the first time.
B. The sign informs the operator of the
following:
Before changing the tool, stop the machine,
switch off the compressed air supply and
bleed the machine by activating the start
and stop device. Use approved personal
protective equipment, including impact
resistant safety glasses with side protection,
to reduce the risk of being injured by a
projectile.
12
B

installation

hoses and connections

Connections between the compressed
air source and the machine
Select the correct dimension and length for the

compressed air hose. For hose lengths up to
100 feet (30 m), use a hose with a minimum
internal diameter of 3/4 in. (19 mm). If the hose
length is between 100 and 300 feet (30-100 m),
use a hose with a minimum internal diameter of
1 in. (25 mm).
Blow any impurities out of the compressed air

hose before connecting it to the machine.
Check that you are using the correct

recommended operating pressure, 6 bar (e).
A
C
B
A. Compressed air source
B. Water separator (optional)
C. Lubricator (optional)
D. Max. 10 feet (3 m) compressed air hose
between the lubricator and the machine.
methods to prevent
freezing
Ice formation in the muffler can occur when the
ambient air temperature is 32-50 °F (0-10 °C) and
the relative humidity is high.
The machine is designed to avoid the formation
of ice in the muffler. Despite this, under extreme
conditions ice can form in the muffler.
The following actions can be taken to further
counteract the risk of ice formation:
1. Use an air tool oil containing antifreeze
agents.
2. Use a water separator.
CP 4123, CP 4125
D
9800 0606 90