Publicidad
Step 16
Fasten the TOP (E) to the BACKS (J and H). Tighten
å
four TWIST-LOCK® FASTENERS.
Fasten the TOP (E) to the UPPER ENDS (A and B).
å
Tighten eight HIDDEN CAMS.
Turn two CORD CLIPS (9P) into the bottom surface of
å
the TOP (E).
The large hole is
closer to this edge.
9P
www.sauder.com/services
H
J
A
B
E
A
J
B
424127
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Dowel end
Maximum
210 degrees
Minimum
190 degrees
®
FASTENER
Arrow
Page 21
Publicidad
