Descargar Imprimir esta página

Sauder Cannery Bridge 426140 Folleto De Instrucciones página 22

Publicidad

Step 16
Step
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into the RIGHT END (A) until the shoulders of the SCREWS rest on the
surfaces of the RIGHT END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the remaining END MOLDING (F) onto the RIGHT END (A). Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the RIGHT END.
å
NOTE: The MOLDING should be even on both edges of the ENDS.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
Page 22
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
A
426140
F
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
www.sauder.com/service
32S

Publicidad

loading