Publicidad
Step 26
Step
1
D28
O
Groove
å
Insert the LARGE DRAWER SIDES (D28 and D29)
at an angle into the slot at each end of the LARGE
DRAWER FRONT (O).
3
Be sure the DRAWER
BOTTOM inserts into the
DRAWER BACK groove.
å
Fasten the LARGE DRAWER BACK (D151) to the LARGE DRAWER SIDES (D28 and D29). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D954) inserts into the groove of the DRAWER BACK (D151).
Page 32
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
D151
D28
D954
D29
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the LARGE DRAWER BOTTOM (D954) into the
grooves in the LARGE DRAWER SIDES (D28 and D29) and
LARGE DRAWER FRONT (O).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
426140
9
With the palm of
your hand, tap
the DRAWER
U n
fi n
BOTTOM down
s u
i s h
r f a
e d
into the groove.
c e
D954
D28
D29
O
30S
(4 used in this step)
www.sauder.com/service
Publicidad
