Drive AQUAJOY SAVER Instrucciones De Funcionamiento página 17

How to re-attach the Actuator to the SAVER Bathlift:
 Ensure the actuator latch at the back of the seat is open
 Place the bottom end of the actuator in the locator hole on the bottom of the bathlift
frame (Fig 11)
 Lift the latch on the top of the seat and lift the seat sufficiently to allow the Actuator to
fit underneath the latch
 Once the Actuator is in the locater at the bottom of the bathlift and under the latch at
the top of the bathlift push down to close the latch
 Close the bottom bracket around the actuator and push it down to secure it in place
(Fig 13)
 Insert the actuator holder securing pin.
 PLEASE ENSURE THAT THE ACTUATOR IS IN THE LOCATOR HOLE AND THAT BOTH THE
ACTUATOR BRACKET AND THE ACTUATOR LATCH INCLUDING PIN ARE FULLY
ENGAGED BEFORE OPERATION
Fig 12
(Fig 12)
(Fig 14)
Fig 10
Fig 13
(Fig 10)
Fig 11
Fig 14
17