Drive AQUAJOY SAVER Instrucciones De Funcionamiento página 9

How to charge your Aquajoy Saver Hand Control
 For safety reasons, please ensure that you do not charge your
battery hand control in your bathroom.
 Connect the battery hand control cable to the charger cable by matching connections
together.
 Insert the charger plug into the outlet.
 Please leave your battery hand control on charge for approximately
you first receive your bathlift.
 When charging the hand control the
 When the hand control is not in use on the bath lift, please leave it on charge
continuously. You can not overcharge the battery hand control.
 Charging the battery hand control continuously uses as little as 0.1 kwh per day
using very minimal consumption.
 When connected to the bathlift there shouldn't be any light on the hand control.
If the LED indicator light shows
have sufficient battery charge. Please recharge your hand control.
 When using the hand control please press the up or down button continuously to
raise and lower the bathlift.
Indicator Light Should
Remain AMBER when the
Hand Control is charging
Amber light will be seen.
Red when connected to the bathlift then you do not
12 hours
Match the hand control
connector and the charger
connector together
when
9