Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. LEARNING SEQUENCE FOR BUTTONS
This interface is equipped with a receiver, which allows to memorize 4 buttons. The memorized buttons have the
following functions:
• The first memorized button will contemporarily activate the outputs OPEN 1 and OPEN 2
• The second memorized button will contemporarily activate the outputs CLOSE 1 and CLOSE 2
• The third button will activate the output OPEN 1
• The forth button will activate the output CLOSE 1
These outputs can be connected to the control units and allow both a simultaneous control of the gates (thanks to the
first and second memorized buttons) and the control of one of the two control units (thanks to the third or forth memo-
rized button). The working type of the receiver is DEAD MAN and therefore the output remains active for the time the
button of the transmitter is pressed.
4. HOW TO MEMORIZE THE CODE OF A TRANSMITTER
1. Supply power between the clamps 13 and 14.
2. You can carry out two different types of procedures for activating the learning modality (the led will turn on per-
manently):
a. Press the learning button of the interface for a moment, the led 1 will turn on fix.
b. Press the hidden button of an already memorized transmitter, the led 1 will turn on fix.
3. Press the button of the transmitter you want to learn the code, the led carries out 2 flashes and afterwards turns
off.
4. For memorizing the following button of the transmitter repeat the procedure starting from point 2. Carry out the
learning of the transmitter by following the sequence described on paragraph 3.
5. Repeat the sequence of the operations starting from point 2 to point 4 for all transmitters to learn.
1
5. HOW TO MEMORIZE THE CODES OF MORE TRANSMITTERS (MULTIPLE LEARNING)
1. Supply power between the clamps 13 and 14.
2. Press the learning button for 3 seconds, afterwards release the button. The receiver indicates the entrance in the
multiple learning with two flashes, afterwards it turns on permanently.
3. Press the buttons of the first transmitter to by flashing two times the correct learning with the pressed button by
flashing two times.
4. By pressing the remained buttons of the transmitter to memorize, the learning of the respective codes will be
carried out.
5. For leaving the multiple learning press the button of the receiver for a moment. The led 1 turns off.
4 / 8
2
3
4
5
6
6-1621987 rev. 3
Publicidad
Tabla de contenido
