Allmatic B.RO4CM2CT Manual De Instrucciones página 13

6. HOW TO CANCEL ALL CODES OF THE TRANSMITTERS
1. Cut off power supply from the receiver's card.
2. Keep pressed the learning button and supply power again to the receiver: the led1 turns on after approximately
3 seconds.
3. Release the button of the receiver.
4. All codes are cancelled when the led turns off.
7. DIAGNOSIS OF RADIO INTERFERENCE
The receiver is equipped with a led (LED 2) for the diagnosis of the radio: the installer is able to find out immediately
if there are radio disturbs which could influence negatively the maximum range of the radio. Check the presence of
disturbs between a transmission and the other considering the following table:
8. CONNECTION OF THE BOARD B.RO4CM2CT WITH TWO BIOS1
REMOVE RADIO
MODULE
6-1621987 rev. 3
Led turned OFF
Led flashing
Led always turned ON
15 16 17 18 19 20 21 22 23 24 25 26 27 28
ATTENTION!
USE ONLY THIS
RADIO MODULE.
MOTOR 2 OUTPUTS
1 2 3 4 5 6
no disturbs
light disturb
presence of heavy disturb
MOTOR 1 OUTPUTS
230Vac
main
7 8 9 10 11 12 13 14
power
supply
REMOVE RADIO
MODULE
FTALL7 FTALL7
Rx Tx
+ -
1 2
+ -
1 2 3 5
5 / 8