Electrical Connection - Reverberi TAL M300H Instrucciones De Uso E Instalación

Manuale del d'uso ed installazione – M300H-M350H
(GB) INSTALLATION
The table must be set properly, adjusting if necessary the height of the feet (M). It is not necessary to fix the
machine to the floor.

ELECTRICAL CONNECTION

The table has no general switch. Therefore it must be connected to a socket with 16 A minimum intensity,
fitted with a switch and a magnetothermic differentials of at least 3 mm.
OPERATION TO FOLLOW FOR THE WORKING OF THE MACHINE
1) Connect the general switch on the feeding line.
2) Put the adjusting thermostat (A) on position "5" (about in the middle of the regulation dial). In this way
the temperature of the working board is about 80°C.
3) At this point, the switch lamp (C) alights.
4) Await a few minutes until when the temperature of the working board is reached (in this moment the lamp
(C) is out).
5) To be able to profit by the depression on the board, be sure that the handle (D) is in position (1).
6) Press the pedal (E). The motor of suction will start working. (The motor remains connected until when the
pedal (E) is pressed).
ATTENTIONS
1) The maintenance has to be carried out exclusively by specialized staff.
2) Replace periodically the cover cloth of the table to enable a correct suction.
3) The working table has never to be left when the iron is feeded and leant on the cover cloth; in any case the
suction table and the iron have to be switched off and the iron placed on its support.
INSTALLATION OF THE SHAPE
It is possible to set a machine which allows to use an ironing shape. The suitable accessories are needed and
the following operations are necessary:
1) Take off the closing plug (F).
2) Insert the steam tube (N). - TAR -
3) Take off the 4 closing screws.
4) Put the support for swiving arm (H) in the 4 bolts of the table.
5) Tighten properly the screws and put the swiving arm (L) in the support (H).
6) Put now the requested shape.
WORKING OF THE SHAPE
Many shapes are internally heated. To be able to use this possibility the following operations are needed:
1) Plug in the shape' s plug in the socket (G).
2) Press the switch for the starting of shapes (B). This switch is provided with internal lamp which indicates
the working of the heating element of the shape. The shape is connected to the adjusting thermostat (A)
which drives the heating element of the board. When the board reaches the working temperature, also the
heating element of the shape is off; therefore in the correct working of the board with the shape, the
switch lamps (C) and (B) light up and off at the same time (when the switch (B) of the shape is on).
3) Also for the shape it is possible to have the depression created by the motor. In the normal working the
table concentrates the depression in the working when the lever (D) is in pos. (1). In this condition the
shape receives only a small part of the total suction of the machine. To concentrate the total
depression on the shape it is sufficient to put the lever (D) in position (2).
OPERATION TO EXECUTE AT THE END OF THE WORK
1) Disconnect the switch of the shape.
2) Disconnect the general switch.
del 03-01-2007 - C:\SETTORE STIRO\M350H98-M350HS98\MANUALE ISTRUZIONI\M300H-M350H.doc Pag. 12 di 22