Rules For Safe Operation - Ega Master EGA Tronik 51247 Manual De Instrucciones

To avoid possible electric shock or personal injury, and to avoid possible damage to the
- Before using the Meter inspect the case. Do not use the Meter if it is damaged or the case
- Do not apply more than the rated voltage, as marked on the Meter, between the terminals
or between any terminal and grounding. If the value to be measured is unknown, use the
- When measurement has been completed, disconnect the connection between the test
leads and the circuit under test, remove the testing leads away from the input terminals of
- The rotary switch should be placed in the right position and no any changeover of range
- Do not carry out the measurement when the Meter's back case and battery compartment
- Do not input higher than 600V between the two Meter's input terminal to avoid electric
- When the Meter working at an effective voltage over 60V in DC or 30V rms in AC, special
Warning!
- Do not use or store the Meter in an environment of high temperature, humidity, explosive,
inflammable and strong magnetic field. The performance of the Meter may deteriorate after
- Replace the battery as soon as the battery indicator
Meter might produce false readings that can lead to electric shock and personal injury.
- The internal circuit of the Meter shall not be altered at will to avoid damage of the Meter
servicing. No abrasive and solvent should be used to prevent the surface of the Meter from
- Turn the Meter off when it is not in use and take out the battery when not using for a long
- Constantly check the battery as it may leak when it has been using for some time, replace
22

RULES FOR SAFE OPERATION

Meter or to the equipment under test, adhere to the following rules:
(or part of the case) is removed. Look for cracks or missing plastic.
Pay attention to the insulation around the connectors.
- Inspect the test leads for damaged insulation or exposed metal. Check the test leads
for continuity. Replace damaged test leads with identical model number or electrical
maximum measurement position and reduce the range step by step until a satisfactory
the Meter and turn the Meter power off.
shall be made during measurement is conducted to prevent damage of the Meter.
are not closed to avoid electric shock.
care should be taken for there is danger of electric shock.
- Use the proper terminals, function, and range for your measurements.
- When using the test leads, keep your fingers behind the finger guards.
- Disconnect circuit power and discharge all high-voltage capacitors before testing
- When servicing the Meter, use only the same model number or identical electrical
- When servicing the Meter, use only the same model number or identical electrical
- Soft cloth and mild detergent should be used to clean the surface of the Meter when
the battery as soon as leaking appears. A leaking battery will damage the Meter.
specifications before using the Meter.
reading is obtained.
shock and damages to the Meter.
dampened.
resistance, continuity and diode.
specifications replacement parts.
specifications replacement parts.
and any accident.
corrosion, damage and accident.
- The Meter is suitable for indoor use.
time.
appears. With a low battery, the