Basic Operations; Turn On; Set Up Wireless Connection Manually; Adjust Volume Level - Vieta Home VH-SB300BK Manual De Usuario

Basic Operations

Turn On

1. Press "Standby" button on main unit or remote
control to turn on the main unit.
2. Wait for automatic setup of wireless connection
between main unit and sub-woofer.
- Power indicator flashes
- if the connection succeeds, the power indicator
of main unit turns BLUE and the pair indicator of
subwoofer turns BLUE too.
- if the connection fails, the power indicator turns
PURPLE, and the pair indicator stays RED or
PURPLE.
- if the connection fails, set up the connection
manually.
Note:
- If a TV or external device is connected to this
unit, it will turned on automatically when the TV or
external device start working.
- If TV/external device is disconnected with this unit
or turned off, main unit will turned off automatically
after one minute.
- If the volume of TV/external device is too low, main
unit will turned off automatically after one minute
also.

Set up wireless connection manually

1. In standby mode, press and hold "VOLUME +"
button on main unit for 3 seconds.
- Power indicator blinks (RED)
2. Press and hold "PAIR" button on subwoofer for 3
seconds
- Pair indicator blinks alternately (BLUE & PURPLE)
- If both indicators flash at a high frequency, then
both indicators turns red, the connection succeed.
- If both indicators are keep on blinking, it means
connections fails.
Note: if the wireless connection fails again, check if
there's a conflict or strong interference (for example,
interference from electronic device) around your
location, after remove those conflict or strong
interference, repeat above procedures.
16

Adjust Volume Level

During play, press the VOLUME+/- buttons to
increase/decrease the volume level.

Super Bass Boost

Press the RS-BASS button to turn on the bass, the
indicator flashes for a longer time (abouts 1s-2s).
Press this button again to turn off the bass, the
indicator flashes for a shorter time (about 0.5s-1s).

Mute Sound

During play, press the MUTE button to mute or
restore sound. Press this button again or
VOL+/VOL - buttos to cancel the effect.
Program Smart Remote Control to
Control TV
You can store a total of 7 most frequently used
function of you TV in the TV (learning zone) of smart
remote control. This feature allows you to use only
one remote control to operate all of your TV.
By default, the remote control codes of a TV are
stored in the smart remote control. The available
preset buttons are ON/OFF, FUNCTION, ENTER,
TV VOL+/VOL-, TV CH+/CH-.
Note: During the learning process, the normal
remote control functions are disabled.
1. Place the smart remote control (A) within 5mm-
50mm distance from TV remote control (B).
2. Press and hold LEARN button for 2 seconds to
activate the learning mode. A red indicator on the
smart remote control (A) lights up.
2.1 SOUND PROJECTOR