Plc Configuration - Ecolab 202580 Manual De Instrucciones

Configuringa PROFIBUS-DP-System
4.4.3

PLC configuration

1.
Start the PLC software.
2.
Open the hardware configuration and execute the menu command
'Install new GSD' .
The new GSD file will be read in, processed, and the Type 202580 inserted into the
hardware catalog.
Fig. 14: GSD-Generator
3.
Open the hardware catalog and place the new device on the work surface.
Via the GSD file of the slaves, the master receives information on which baud rates
are supported.
Fig. 15: GSD-Generator
4. Load the configuration into the PLC (Target system / Load into module).
Fig. 16: GSD-Generator
417102396 Rev. 1-10.2019 30