Setting Up The Spa Status Transmitter - Aeware in.watch El Manual Del Propietario

getting started

Setting up the spa status transmitter

Connect the spa status transmitter to the appropriate cable
adapter that comes with the kit.
For MSPA-MP & M-Class spa systems:
• On MSPA-MP & M-Class spa systems, use Mini DIN to 4-pin
MTA-100 cable adapter (P/N 9920-401030).
P4 connector on PCB ( "I2C" or "COM")
to Mini-DIN Female
MTA-100 Male connector to device
Spa Status Transmitter
(spa watch, in.watch, TSC-24, djs, etc)
• Open the front cover of the MSPA-MP or M-Class spa system
to get access to the spa controller printed-circuit board (PCB).
Please refer to the spa user's manual for more details.
• Disconnect the device connected to the P4 connector on the
printed-circuit board labeled "I2C" or "COM" (e.g.: spa watch,
in.watch, TSC-24, djs, etc).
• Now, connect that device to the MTA-100 male connector
of the cable adapter.
8
MTA-100 Female connector to
• Finally, connect the MTA-100 female connector of the cable
adapter to the P4 connector on the spa controller printed-
circuit board (PCB).
MTA-100 Male
in.watch
Spa status
transmitter
MTA-100 Female