Dual-Connect Split - See Pages - Steelcase Answer Boundary Screens Manual De Instrucciones

®
Dual-Connect Split Installation
1.
Install Answer End-Of-Run (EOR) vertical
junction as shown on Answer panel assembly
direction # 939504607.
2.
Place each split boundary screen on a clean,
scratch resistant surface and install a glide on the
bottom of each screen. See step 11 on page 5 for
installation process.
TIP: Start with the screen that contains the side
pockets where the modeez clips are installed.
3.
Place upper hook bracket into pocket on
boundary screen and install five (5) flat head wood
screws (provided).
4.
Lift split boundary screen and insert hooks into
Answer EOR vertical junction (as shown) and press
down to install.
TIP: Use suction cup holders to help this installation
process.
5.
Insert toe of lower hook bracket into the
appropriate slot (a) and swing into position (b),
lift lower hook bracket (c) and swing down into
pocket on boundary screen (d).
6.
Install five (5) flat head wood screws (provided).
ANSWER EOR
VERTICAL
JUNCTION
d
5
c
LOWER HOOK
BRACKET
(RH SHOWN)
ANSWER EOR
VERTICAL JUNCTION
6
b
a
3
UPPER HOOK
BRACKET
(RH SHOWN)
4
Page 9 of 39
73085 Rev E