Pedal Programming - Studiologic VMK-149plus Manual De Instrucciones

I n s t r u c t i o n m a n u a l
PROCEDURE: PEDAL PROGRAMMING
We will program PEDAL INPUT 1 to transmit Sustain. For this procedure you will need a Sustain Pedal. Any polarity
pedal will work.
TIP: The three PEDAL INPUTS may be programed to transmit anything from Sustain to Volume to even Modulation.
A PEDAL INPUT, when connected to a Volume Pedal , can transmit the same CNTRL Values as the SLIDERS or KNOBS.
Remember, you have three PEDAL INPUTS to work with. Imagine in a live set-up, two volume pedals set-up to con-
trol two different sounds. In our set-up you would program PEDAL 1 so its Polarity would be DN>UP, and PEDAL 2
so it's Polarity would be UP>DN. By pressing down on both volume pedals, you would fade out of one sound and fade
into the other! All without awkward foot movement.
1) PRESS EDIT
2) PRESS PEDAL
In this example set the Midi
Channel to 1
Remember: the sustain
Pedal must be plugged
into PEDAL INPUT 1
3) PRESS PAGE UP
We need to set the
CTRL Change to 64
That's the Midi Spec for
Sustain Pedal.
4) PRESS PAGE UP
Set the Value Min. to 0
In this case any Value below
<64 will transmit an off Message.
5) PRESS PAGE UP
Set the Value Max to 127
In this case any Value above
>64 will transmit an on Message.
VMK-149plus/VMK-188plus
SCREEN
CHANGE
To adjust the Midi Channel use the DE knob
SCREEN
CHANGE
To adjust the CTRL Change use the DE knob
SCREEN
CHANGE
To adjust the Value Min. use the DE knob
SCREEN
CHANGE
To adjust the Value Max use the DE knob
SCREEN
CHANGE
17
p e d a l s
PRESS OR MOVE
ANY CONTROLS
EDIT PEDALS: -1-
MIDI CHANNEL OFF
EDIT PEDALS: -1-
CTRL CHANGE 64
EDIT PEDALS: -1-
VALUE MIN: 0
EDIT PEDALS: -1-
VALUE MAX: 127