Danby Silhouette Professional SPRWC053D1SS Manual Del Propietário página 8

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the door pins from the upper and lower
hinges. Remove the door from the cabinet.
2. Remove the hinge covers from the upper and
lower hinges. Remove the hinges from the
cabinet. Remove the screw hole covers from the
left side of the cabinet. Install the screw hole
covers in the screw holes on the right side of
the cabinet. Install the upper right hinge on the
bottom left of the cabinet. It doubles as the lower
left hinge. Install the lower right hinge on the
upper left side of the cabinet. It doubles as the
upper left hinge.
3. Remove the door latch and the actuator from the
bottom of the door. Install them both in the screw
holes at the top of the door.
4. The door will need to be rotated 180° before
being reinstalled on the cabinet to ensure that
the door handle is on the correct side and that
the door latch and actuator are at the bottom
of the door. Ensure that the top of the door is
aligned with the top of the cabinet, that the
actuator is making contact with the switch and
that the rubber gasket is making contact with
the cabinet all the way around the door before
tightening the hinge screws.
5. Open the door 90° and reinstall the hinge
covers.
A. Door
B. Door pin
C. Screw hole cover
D. Upper hinge
E. Upper hinge cover
F. Latch
G. Actuator
1
2
C
3
F
4
D
5
D
E
7
B
A
D
G
B
A
D
A
A
E
E