Sinbo SK 2357 Manual Del Usuario página 9

INSTRUCTION FOR USE
3. Fill the kettle with cool water up to the "MAX" mark and boil it. Empty the kettle. The
appliance is ready for use.
INSTRUCTION FOR USE
FILTER PLAGING
1. Open the lid by pressing on the lid release button.
2. Place the filter between the two grooves near the spout at the front of the kettle.
3. Ensure that the filter is pressed down to the bottom of the grooves and fits correctly
then close the lid.
NOTE: Never leave the filter loose in the kettle. Never remove the filter while the kettle
contains hot water.
FILLING
1. Remove the kettle from the base unit.
2. You can fill the kettle with water via the spout or by opening the lid, by pressing on the
lid release button.
3. Not recommend to fill with less than 1liter of water to prevent the kettle running fry
while operating.
4. Do not fill with more than 1.5 liters of water (up to "MAX" mark).Avoid overfilling to
prevent the water spilling out during the boiling process.
SWITCHING ON
1. After filling your kettle with water, place the kettle on the base unit.
2. Connect plug to power supply and pull down the On/Off switch.. The appliance will
begin to operate and the indicator light will come on.
SWITCHING OFF
When the water boils, the kettle will switch off automatically and the indicator light will
go off.
NOTE: This appliance has a safety system, which automatically switches off the heater
element if the appliance is inadvertently switched when empty, or if it boils dry. In this
case, let the appliance cool down completely, before filling with water again.
SWITCHING ON AGAIN
The kettle can be switched on again after cooling down about 15-20seconds, while the
kettle has been switched off automatically.
CARE AND CLEANING
1. Always remove the plug from the power supply and let the appliance cool down
completely.
2. Clean the outside of the kettle and the base unit with a soft damp cloth. then wipe with
- 8 -