Chapin ProSeries SMKCPD0015L Manual De Instrucciones página 2

WARNING: Improper use or failure to follow instructions can result in
explosive failure causing serious eye or other injury. For safe use of this product
you must read and follow all instructions. Do not leave a pressurized sprayer in the hot
sun. Heat can cause pressure build-up resulting in possible explosion. Do not store or leave
solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and
full foot protection when spraying. Never use any tool to remove pump if there is pressure
in the pressure chamber. Never pressurize sprayer by any means other than the original
pump. Do not attempt to modify this sprayer. Replace parts only with manufacturer's
original parts. Never spray flammable, caustic, acidic, chlorine, bleach or other
corrosive solutions or heat, pressure, or gas producing chemicals. Always
read and follow chemical manufacturer's instructions before use with this
sprayer as some chemicals may be hazardous when used with this sprayer.
• PRE-USE CHECK: Before each use check tightness of hose nut to be sure hose is
securely attached to the shut-off assembly. Insure hose is securely attached to the
tank by tightening hose clamp if necessary. Insure that all nozzle and wand
connections are tight. Insure the large pump clamp is tight. Insure the 2 bolts
used to attach the pump lever to the pump shaft are tight.
• Do Not exceed a tank solution temperature of 120º F/ 49º C.
NOTE: The tank and hose may have residual water in it due to quality testing
performed on the sprayer.
WARNING
CAUTION
1E
SK 1158-1