Warning; Commissioning; Checks Before Commissioning; Checking The Direction Of Rotation - Grundfos Servomotors 384-511 Instrucciones De Instalación Y Funcionamiento

Use separate, shielded lines for low
Note
voltages (e.g. potentiometers, analogue
signals).
Use screwed cable joints appropriate for
the connection line.
Note
The stated degree of protection can only
be ensured if suitable screwed cable joints
are used.

Warning

The internal wiring of the drive must never
be modified.

10. Commissioning

Warning
The drive may only be commissioned if the
hood and cable entries are properly
closed.
Warning
Please note that the process of
commissioning the drive will cause
associated fittings/levers/rodding to move.
Warning
Check that all emergency
equipment/functions on your
machine/installation are working correctly.
Warning
Once all adjustment work has been
completed, check that the drive and the
fittings/levers, etc. operated by it are
working correctly.
Warning
Never work with a damaged drive.
When commissioning, all the installation's
Caution
components must be ready for operation.
Follow the installation and operating
Note
instructions for the components used.

10.1 Checks before commissioning

Before setting the servomotor to automatic
Caution operation, check the min./max. position
and the direction of rotation.

10.1.1 Checking the direction of rotation

The servomotor is controlled by an external
controller. This means that the servomotor's direction
of rotation depends on the controller's cabling and
settings being correct.
12
Observe the installation and operating
Note
instructions for the controller and the
dosing pump.

11. Operation

Observe the supplier manual "TBasic_BA" for the

servomotor provided with the product.

Warning
The terminals at the limit switches are live
when the switch closes.
Switch cams and limit switches are set at
Caution
the factory and must not be modified.
Warning
Do not touch bare wires or clamping
screws.

12. Maintenance

The servomotor features permanent
Note
lubrication and is maintenance-free.
Warning
Switch off the entire installation before any
repair work is carried out.
Disconnect the supply voltage before
opening the housing.

13. Disposal

This product or parts of it must be disposed of in an
environmentally sound way:
1. Use the public or private waste collection service.
2. If this is not possible, contact the nearest
Grundfos company or service workshop.
The crossed-out wheelie bin symbol on
a product means that it must be
disposed of separately from household
waste. When a product marked with this
symbol reaches its end of life, take it to a
collection point designated by the local
waste disposal authorities. The separate collection
and recycling of such products will help protect the
environment and human health.
See also end-of-life information at
www.grundfos.com/product-recycling.