Angelcare AC315 Manual Del Usuario página 6

Monitor de respiración de bebés con video
Ocultar thumbs Ver también para AC315:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6
5
Sensor Pad
1) Insert jack 1 into the Sensor Pad and twist it clockwise to lock it. Gently pull on the cord to ensure
it is locked.
jack 1
2.2 - SELECT THE CRIB LEG TO SECURE THE CORD COVERS
RECOMMENDED
6
Use the crib leg by the wall closest to the Camera (Figure 1). In cases where the Camera is across the room, use
the leg closest to the Camera to position the covered wire (Figure 2). It is always preferable that the covered
cord run along a wall.
2.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
• If your crib does not have a solid, stationary, completely flat, firm surface including
a spring or slat base, place a hard board between the crib base and the Sensor
Pad, to ensure correct operation. The hardboard support must measure at least
33 x 33 cm (13" x 13") and 6 mm (1/4") thick. This hardboard support must be
larger than the Sensor Pad surface area.
• The Sensor Pad functions with any size and type of mattress except memory-foam
mattresses, hollow frame mattresses and water beds. The hardboard maintains a constant pressure on the
Sensor Pad, enabling it to detect the baby's movements even when the baby is at the edges of the crib.
6
MUST BE MORE
THAN
3 FEET
(1 METER) AWAY
OR
4
3
2
1
6
5
4
3
2
Figure 1
1
6
5
Sensor Pad
5
4
3
2
OR
2
1
MUST BE MORE THAN
3 FEET (1 METER) AWAY
4
3
2
1
jack 2
jack 3
1
6
5
4
3
Figure 2
Hardboard

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido