KRESS 144 KAP Manual Del Usuario página 21

Operation
Operation
Remove battery
Pull battery8 out from the handle by pressing on
the battery lock 9 at the same time.
Insert battery
Press the charged battery 8 into the power tool un-
til it engages fully.
Charge battery
Only insert original batteries in the charger
provided.
Plug in the charger 11 mains plug.
Push battery 8 into the charger 11 as far as it will
go.
The LED 12 flashes green. The charging process
is running.
Permanent green light. The battery is charged; the
charger has switched to maintaining charge.
Unplug the charger mains plug if the charger
is unattended.
During the charging process both the battery
and the charger heat up.
LED charge level indicator12
Flashing green The charging process is running
light
Permanent The battery is fully charged, the
green light
charger has switched to maintain-
ing charge.
Quickly flashing Battery has no contact or is too
green light
warm. Remove battery from the
charger and reinsert or allow to
cool to room temperature and
restart the charging process.
Switching on/off
Press or release the On/Off switch 7.
Setting the Working Pressure
The working pressure and thus the extrusion
speed of the material have an infinitely variable
setting by means of the regulator 5. In this way,
the extrusion of the material can be adapted opti-
mally to the differing widths of crack and working
speed.
Setting „+" high extrusion speed/quantity
Setting „-" low extrusion speed/quantity
-NOTE-
Select a higher setting for less viscous material.
The speed can be changed during operation.
Inserting the cartridge
-NOTE-
Do not use damaged cartridges.
Compressed air could otherwise leak. Check, in
particular, the lower edge of the cartridge for
damage or deformations.
1.
2.
Cut open the connection nipple on the cartridge,
or if necessary, pierce the aluminium seal. In so
doing, observe the manufacturer's instructions
written on the cartridge.
Unscrew the application nozzle 1 and make a di-
agonal cut to match the desired width of the crack.
Push the prepared cartridge into the cartridge
plunger tube 3 from the front and tightly screw on
the cap 2.
Ensure that the screw cap is firmly seated.
There is an increased risk of injury from
debris being projected.
English 21
EN
3.
KAP-EN / 0802