How It Works; How To Install - GOAL ZERO YETI LINK Manual Del Usuario

HOW IT WORKS

The Goal Zero Yeti Link Expansion Module integrates with a Goal Zero
Yeti Lithium Portable Power Station and Goal Zero Yeti Tank Expansion
Battery to increase your energy storage capacity. The Link is a 65 Amp
Lead-Acid to Lithium Charge Controller that allows you to chain lead-acid
batteries to a Yeti Lithium power station.
Goal Zero Goal Zero Yeti Lithium and
Solar Panels Goal Zero Yeti Link Expansion Module
(Sold Separately)
REQUIRED (sold separately)
WARNING: Never connect a power source to the Link before
installing into the Yeti. Always connect the Link to the Yeti before
connecting any power source.
4 4
Goal Zero Yeti Tank
Expansion Battery
+
REQUIRED (sold separately)

HOW TO INSTALL

Tools you'll need: Screwdriver
1. Turn off all the output ports and unplug the Yeti from any power
source.
2. Open the lid of the Yeti and remove the expansion module carriage
from the Yeti by removing the six screws and sliding out the
carriage.
a. Use both hands to work the expansion module carriage out of
its position.
WARNING: Do not exceed 22V input for the module. Doing so
can cause serious damage to the Yeti and potential bodily injury.
Take note of voltages when using third party solar panels with the
module. Do not chain solar panels in series (positive to negative,
positive to negative, etc.), as this can result in dangerously high
voltages.
5 5