Charging Indicator Lights; Frequently Asked Questions - GOAL ZERO YETI LINK Manual Del Usuario

+
-
Blue Connector
3. Take note of the positive and negative terminals on the Yeti's module
port, as well as on the Link's blue connector. Insert the blue connector
into the module port on the Yeti, matching positive to positive, negative
to negative.
4. Insert the micro-USB connector on the Link into the micro-USB port on
the Yeti.
5. Gently set the Link into place, tucking the cables into the opening.
6. Using the provided four screws, secure the Link into place.
7. Using the 8mm port, plug the power source into the Link.
8. Using the External Battery Connector, connect the Tank Expansion
Battery (sold separately) to the Link.
9. When the power source is correctly plugged in, the Input Charge Indicator
light will turn blue. When the Tank is correctly connected to the Link and
the power source is plugged in, the Lead-Acid State of Charge Indicator
light will begin flashing green. NOTE: Upon plug-in, all LEDs will turn
on, then off before correct lights are displayed. This may take up to 30
seconds.
10. Power source will charge the Yeti first. When the Yeti is fully charged,
power will begin to store in the Tank.
6
CHARGING INDICATOR LIGHT
Data Transfer
Input Charge Indicator:
Connector
FLASHING BLUE - Power source is correctly plugged into
8mm input and charging.
Red Cable (+)
BLUE - Lead-Acid battery is full.
Black Cable (-)
Lead Acid State of Charge Indicator:
1 LED LIGHT - Lead-Acid battery is 25% full or less
2 LED LIGHTS - Lead-Acid battery is 25% - 50% full
3 LED LIGHTS - Lead-Acid battery is 50% - 75% full
ALL LED LIGHTS - Lead-Acid battery is 75% full or more
Error LED
FLASHING RED - Yeti is in an over voltage condition or lead
acid battery is in an under voltage condition. Disconnect
all Tank Cables from Link and Yeti and please call our solar
experts at 888-794-6250.
NOTE
The 8mm input port on the Link is the only way to charge both the Yeti and
Tank. Input ports on the Yeti display will only charge the Yeti, not the Tank.

FREQUENTLY ASKED QUESTIONS

Q: I installed my Link into my Yeti, connected my batteries, and I'm not
A: Upon initial installation, the Link needs time to identify which type of Yeti
Q: I'm charging my Yeti and it is connected to one or more Tank batteries,
A: First, make sure you are using the input on your Link to charge your
showing a charge. What's going on?
you own in order to maximize performance. It can take up to 30 seconds
to start operating.
but my Tank batteries are not filling up. What should I do?
system. This input is the only way to charge both your Tank(s) and Yeti
at the same time. If you are using the correct input and still having a
problem, try resetting by reinstalling your Link.
7